Repair 7

How to Install a Water Pump on a 1995 Mitsubishi Mirage

The Mitsubishi Mirage is a subcompact car that was in production until from 1978 to 2002. The 1995 model is a fourth generation Mirage, which includes 1991 to 1996 models. This vehicle was available with a 1.5-liter engine or a 1.8-liter engine, and the water pump replacement procedure is the same for both engines. The water pump in a 1995 Mitsubishi Mirage is located on the front of the engine above the cooling fan.

Instructions

1

Remove the negative battery terminal with a socket wrench to ensure you dont start the engine unintentionally. Place a container under the drain for the radiator and remove the radiator drain cock. Drain the coolant into the container and replace the drain cock. Seal the container of coolant and store it for later use.

2

Disconnect the engine undercover and the bolt for the power steering hose with a socket wrench. Detach the engine drive belts. Support the engine with a floor jack and a wood plank to serve as a cushion for the engine.

3

Disconnect the engine mount bracket and the timing belt with a socket wrench. Remove the power steering pump bracket and the alternator brace.

4

Disconnect the mounting bolts for the water pump and record their position, since they have different lengths. Remove the water pump and its gasket.

5

Clean the mounting surfaces on the water pump and engine block with a shop towel. Lubricate the new O-ring with water and place it into its mounting groove on the water inlet pipe. Install the new water pump and torque the mounting bolts to 17 ft. lbs with a torque wrench.

6

Connect the additional components you removed earlier by reversing steps 2 and 3. Refill the cooling system and connect the battery with a socket wrench. Run the engine until the radiator fills completely. Check the coolant level and top it off to the correct level.