How to Replace the Fuel Pressure Regulator on a Celica
Thursday, November 7, 2013 | Labels: a, celica, fuel, how, on, pressure, regulator, replace, the, to | |Toyota has used the Celica name for a variety of sedans since 1970. The most recent version of the Celica is a 3-door hatchback that was in production from 1999 to 2006. These vehicles have 4-cylinder, 1.8-liter engine with multi-port fuel injection. The fuel pressure regulator in a late-model Celica attaches to the fuel filter and is accessible with an access panel under the rear seat. The replacement of the fuel pressure regulator in a Toyota Celica also requires the removal of the fuel pump assembly.
Instructions
- 1
Open the gas cap to relieve the pressure in the fuel tank. Disconnect the negative battery cable with a socket wrench to avoid starting the engine accidentally. Remove the rear seat cushion and disconnect the screws on the service hole cover. Remove the service hole cover.
2Detach the electrical wiring to the fuel pump assembly. Disconnect the fuel outlet pipe from the fuel pump bracket with tool SST 09631-22020. Remove the retaining screws for the fuel pump bracket with a socket wrench and detach the return hoses from the fuel pump bracket. Pull the fuel pump assembly from the fuel tank.
3Remove the fuel suction support from the fuel pressure regulator with a socket wrench and detach the fuel pressure regulator from the fuel filter. Remove and discard the O-ring for the fuel pressure regulator.
4Coat the new O-ring with a thin layer of gasoline and mount it on the new fuel pressure regulator. Attach the fuel pressure regulator to the fuel filter and install the fuel suction support.
5Install the fuel pump assembly into the fuel tank and connect the return hoses to the fuel pump bracket. Fasten the retaining screws to the fuel pump bracket and connect the fuel outlet pipe to the fuel pump bracket with tool SST 09631-22020.
6Attach the electrical wiring for the fuel pump assembly. Replace the service hole cover and fasten the retaining screws for the cover with a socket wrench. Install the rear seat cushion and connect the negative battery cable.
Post a Comment