Repair 7

Jeep Cherokee Dash Removal

Removing the dashboard on your Jeep Cherokee is a simple, but finicky task. The Jeep Cherokee dashboard includes the lower instrument panel, instrument cluster bezel, radio and heater control panel, and defroster cowl panel.

Remove the Lower Instrument Panel

Remove the lower instrument panel first by removing its four retaining screws. Lower the panel and disconnect all the wire connectors attached to it. Make a note of where each wire connector attaches.

Remove the Instrument Cluster Bezel

Remove the four screws that hold the instrument cluster bezel in place. Unsnap the cluster bezel at the eight snap fit locations. Be gentle on older models of Cherokees to prevent breaking the snaps as they keep the bezel firmly in place and stops it from making annoying rattling noises.

Remove the Radio and Heater Control Panel

Unscrew the two screws holding this panel in place. Pull the radio control panel out and disconnect the electrical connectors to the radio. Pull out the heater control unit.

Remove the Defroster Cowl Panel

Loosen and remove the four screws holding the defroster cowl panel in place. The cowl panel has retaining clips on the drivers side, which must also be removed. Take care not to let the clips fall off the panel when you remove it.