How to Replace a 1994 Corvettes Tail Light

Tuesday, April 29, 2014 | Labels: , , , , , , , | | How to Replace a 1994 Corvettes Tail Light

The 1994 Corvette has tail lights that are readily accessible from the rear of the car. As a result, if you have a tail light burn out, you can replace it in just a few minutes. Make sure that you use the light bulb that is compatible with the socket.

Instructions

    1

    Take the two screws out from either side of the tail light using your Phillips head screwdriver. You can reach them from the rear of the car. See page 198 of the manual in the References section for a diagram.

    2

    Remove the lens, and put it on a safe, level surface.

    3

    Push the burnt-out bulb inward and then turn it counterclockwise, or to the left. Then remove it by pulling it toward yourself.

    4

    Slide the new bulb into the socket. Press it in and turn clockwise, or to the right.

    5

    Replace the tail light lens, and then put the screws back in with the Phillips head screwdriver.

0 comments:

Post a Comment