Repair 7

How to Free Up Frozen Shock Absorbers

There are times when your vehicles shock absorbers freeze, thereby impairing the proper functioning of your suspension system. Releasing the frozen shock absorbers remains a matter of getting in the right position to apply enough torque after lubricating the absorbers with penetrating oil. Applying new absorbers to the suspension system will have you up and running in no time. It is imperative to release the frozen absorbers because your suspension system depends on the absorbers to control the motion of the vehicle. Shock absorbers prevent your vehicle from bouncing on the flexing spring. The absorbers transfer energy created by the spring to a piston, which releases the heat.

Instructions

1

Position the jack by using the jacking points of the vehicle, allowing the jack to support the weight of the car. Then lift slightly without lifting the wheels from the ground. Loosen wheel nuts with a wheel brace and remove the wheels. Raise the car slowly until the tires are just above ground.

2

Remove the interior covering in the trunk to access the upper shock mounting nuts. If needed, use the pliers and wrench to remove hardware to access the lower shock mounting nuts.

3

Spray the upper and lower shock mounting nuts and absorbers with the penetrating oil and allow the oil to soak into the parts before attempting to remove. Wait at least 10 minutes.

4

Dislodge the lower and upper mounting nuts and washers with the wrench and pliers, and remove the old shock absorber.

5

Mount the lower shock mounting nuts and new shock absorber. Tighten the lower mounting bolts to secure torque with the wrench.

6

Install upper grommets and upper mounting nuts. Make sure all grommets are installed in the proper place. Reinstall the wheels. Lower the vehicle and jounce the vehicle four times to settle the grommets.