Repair 7

Installation Instructions for a Ford Keyless Entry Keypad

Installing the keypad to your Ford keyless entry system allows you to control the door locks and trunk from a distance by pressing a button. This is helpful in bad weather or if you forget to lock the door. The keyless entry remote also has a panic button that sounds an alarm when pressed. The panic button is helpful if you get hurt or attacked in a parking lot and need help.

Instructions

1

Put the key into the ignition and turn it from the "Off" position to the "On" position eight times within 10 seconds. Make sure to end with the key turned to the "On" position. Remember, you have more than a full second to complete each turn, so dont panic and make sure to count the number of times you turn the key. When you have done this correctly, the doors lock and unlock to signify the car has entered the programming mode.

2

Press any button on the remote while the car is in the programming mode. The car stays in programming mode for 20 seconds. The car catches the signal and programs the remote to the system.

The car does not stay in programming mode long, so other people cannot program a remote to your car. Repeat this step within 20 seconds of programming the previous remote to program additional remotes. The doors lock and unlock after each remote has been programmed.

3

Turn the key from the "On" position to the "Off" position. This has the car exit the programming mode. The doors lock and unlock to confirm that it has exited programming mode and no other remotes will be able to be programmed to your car without repeating the entire process.